Key Clamp Buggy » 10

Remove the chair from its feet out of steel and their possible feet mounting, to keep only the plastic hull.

Cut 2 600 mm lengths of tube PVC, hot curve them, as on the principal level. It is possible all gently with the top of a stove of camp-site, for example, by paying great attention not to burn PVC…

Flatten the ends (hot also), and bore these ends according to the dimension of the chair. Thread the foam of protection on tubes PVC, protect foam with by a cover (to be made according to the diameter of recovered foam).

Screw the balustrades on the chair with screws and bolts stainless Ø 8 Misters.

Position the seat well fixed on the three tubes (n°2 and 3), then fix firmly, with before on the tube n°2 with screws and bolts stainless Ø 8mm, and with the back by lower part the two tubes n° 3, by means of two pieces of strong strap, screwed with the chair and buckled under the frame. You will be able to improve solidity of sitted and its fixing while passing a “end” behind the file, walking on in the balustrades, which you will firmly tie under the tubes n°3 as for girthing.

Comments are closed.