Making a Stainless Race Buggy » 06 …and then tigged the boss to the inner tube, nothing fancy as the surface of the weld will be cleaned up

06 …and then tigged the boss to the inner tube, nothing fancy as the surface of the weld will be cleaned up

05 First I tigged the tube to the outer tube…
07 Then I use a mop disk to remove the access weld

This entry was posted on Friday, December 16th, 2011 at 8:04 pm. It is filed under . You can follow any responses to this entry through the RSS 2.0 feed. Responses are currently closed, but you can trackback from your own site.

Comments are closed.