Making a Stainless Race Buggy » 13 After the first plate has been tacked, clamp a straight edge onto it, this then gives a perfect face to hold the second plate inline with the first plate.

13 After the first plate has been tacked, clamp a straight edge onto it, this then gives a perfect face to hold the second plate inline with the first plate.

12 After marking from the centre dot (in this case 230mm either side of the centre dot)the two positions of the axle plates, tack the first plate on, either end and both sides.
14 End detail of the straight edge

This entry was posted on Friday, December 16th, 2011 at 8:04 pm. It is filed under . You can follow any responses to this entry through the RSS 2.0 feed. Responses are currently closed, but you can trackback from your own site.

Comments are closed.